Transfer Oil Check

WARNING: This page is about a different variant/trim than selected.

Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
Remove the filler plug and gasket.

Fig 1: Identifying Oil Filler Plug & Oil Drain Plug
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Check that the oil level is not 14 mm (0.6 inch) below the bottom of the oil filler plug hole.
Check that the oil is not excessively foul and has moderate viscosity.
If the oil level is not in between the upper limit and the lower limit, refill the specified oil to the bottom of the oil filler plug hole.
Brand name: DiaQueen LSD gear oil

Fig 2: Checking Oil Level
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb)
Install the engine room under cover front B assembly. (Refer to UNDER COVER .)