Clock Spring Check

If any malfunction is found in the following inspections, replace the clock spring with a new one.

1. Check the connectors and protective tube for damage, and the terminals for deformation.
2. Visually check the case for damage.
3. Check that the continuity exists between the following connector terminals:
   Fig 1: Identifying Connector Terminals

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   • C-204 connector terminal 1 and horn switch connector
   • C-204 connector terminal 2 and C-202 connector terminal 5
   • C-204 connector terminal 3 and C-202 connector terminal 4
   • C-204 connector terminal 4 and C-202 connector terminal 3
   • C-204 connector terminal 5 and C-202 connector terminal 2
   • C-204 connector terminal 6 and C-202 connector terminal 1
     CAUTION: Do not directly insert a probe, etc. into the terminal from the front of the connector.
4. Insert the special tool (MB992006) from behind the air bag module connector of the C-205 driver's side.
5. Connect the circuit tester to the special tool as shown in the illustration, and check the continuity among terminal No. 1 - 2 or No. 3 - 4.
   Fig 2: Checking Continuity Between Airbag Module Connector Terminal No. 1, 2 Or No. 3, 4

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.