Option Coding
Required Special Tools:
- MB991958: Scan Tool (M.U.T.-III Sub Assembly)
- MB991824: Vehicles Communication Interface (V.C.I.).
- MB991827: M.U.T.-III USB Cable.
- MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system).
CAUTION:
- If there is any item indicated by the option coding after equipment change, set ETACS-ECU so that the option coding data corresponds with the equipment content. Functions and systems do not work normally if the setting does not correspond with the equipment.
- With the ETACS functions being customized, if any of the ETACS-ECU variant coding and option coding items are changed, the customized contents are reset. In such case, the functions need to be recustomized.
The engine control module and ETACS-ECU option coding data can be checked or changed by operating scan tool MB991958.
CAUTION:
To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
- How to check option coding data
- Connect the scan tool MB991958.
- Turn the ignition switch to the "ON" position.
- Select "System select" from the start-up screen.
- Select "From 2006 MY" under "Model Year". Check that "Vehicle Information" contents are correct.
- Select "MP/GDI/DIESEL" or "ETACS" from "System List", and then press "OK" button.NOTE: If "Loading Option Setup" list is shown, click appropriate box.
- Select "Coding."
- Select "Option Coding Information."
- Check the displayed option coding information.
- How to change option coding dataCAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
- Connect the scan tool MB991958.
- Turn the ignition switch to the "ON" position.
- Select "System select" from the start-up screen.
- Select "From 2006 MY" under "Model Year". Check that "Vehicle Information" contents are correct.
- Select "MP/GDI/DIESEL" or "ETACS" from "System List", and then press "OK" button.NOTE: If "Loading Option Setup" list is shown, click appropriate box.
- Select "Coding."
- Select "Option Coding."
- Change to correct option coding data.
ENGINE CONTROL MODULE LIST
| Item name |
|---|
| Cruise Control |
ETACS-ECU LIST
| Item name |
|---|
| Auto light CNTL |
| Keyless |
| AUDIO (CAN) |
| Rain Light Sensor |
| AUDIO/S. RADIO type |
| Number of speaker |
| Front fog light |
| Rear fog light |
| Horn type |
| Manner switch |
| Remote engine starter |
| AND |
| HFM (hands free-ECU) |
| Satellite Radio |
| Compressor type |
| Wiper washer check bulb |
| Door Unlock Mode Customize |
| Front wiper |