LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2014 >> Lancer ES, Standard Trans >> Repair and Diagnosis >> Maintenance >> Procedures >> General Information - Lancer >> Precautions Before Service >> Battery Current Sensor Calibration (Non-Turbo) >> Learning Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Learning Procedure

  1. After the ignition switch is in "LOCK" (OFF) position, disconnect the battery cable from the negative battery terminal.
  2. Remove the battery current sensor from the battery cable (Do not disconnect the battery current sensor connector).
  3. Connect the battery cable without the battery current sensor to the negative battery terminal.
    Fig 1: Identifying Battery Current Sensor
    G07028227Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    4. CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
  4. Connect the M.U.T.-III to the data link connector (But do not start the engine).
  5. Turn the ignition switch to the ON position.
  6. Select "MFI" from System select Screen of the M.U.T.-III.
  7. Select "Special Function" from MFI Screen.
  8. Select "Learning" from Special Function Screen.
  9. Select "Battery current SNSR.calibration" from Learning Screen.
  10. Start the calibration by pressing the "OK" button.
  11. Confirm that the M.U.T.-III data list item No. 119 Battery current sensor calibration is "Completed".
  12. After the ignition switch is in "LOCK" (OFF) position, disconnect the M.U.T.-III.
  13. Install the battery current sensor.
    Fig 2: Connecting Special Tool MB991827 To Special Tool MB991824
    G05374606Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals