LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2014 >> Lancer Evolution GSR >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Active Stability Control System (ASC) - With Diagnostics - Lancer Evolution >> Diagnosis >> Diagnostic Trouble Code Procedures >> DTC U1415: Variant coding not completed >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC U1415: Variant coding not completed: Notes

CAUTION:
  • If there is any problem in the CAN bus lines, an incorrect diagnostic trouble code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to CAN BUS LINE DIAGNOSTIC FLOW ).
  • Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
  • When diagnostic trouble code No. U1415 is set in ASC-ECU, the diagnostic trouble code may also be set in ETACS-ECU. When the diagnostic trouble code is set in ETACS-ECU, perform the diagnosis of the diagnostic trouble code for ETACS-ECU first.
  • When the hydraulic unit (integrated with ASC-ECU) is replaced, after turning the ignition switch ON and OFF (vehicle information from ETACS-ECU is registered), always perform the calibration of steering wheel sensor, G and yaw rate sensor, brake fluid pressure sensor, cut valve, and inlet valve (Refer to G AND YAW RATE SENSOR CALIBRATION  , STEERING WHEEL SENSOR CALIBRATION  , MASTER CYLINDER BRAKE FLUID PRESSURE SENSOR CALIBRATION  , and CALIBRATION OF CUT VALVE AND INLET VALVE  ).
scientia non olet · About LEMON Manuals