LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2014 >> Lancer Evolution MR >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Supply System - Lancer Evolution >> On-Vehicle Service >> Fuel Level Sensor (Sub) Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Level Sensor (Sub) Replacement

  1. Remove the rear seat cushion assembly. (Refer to REAR SEAT ASSEMBLY ).
  2. Remove the floor inspection lid (RH).
    Fig 1: Identifying Floor Inspection Lid (RH)
    G09640858Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. Disconnect the fuel level sensor (sub) connector.
    Fig 2: Identifying Fuel Level Sensor (Sub) Connector
    G09640859Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CAUTION: Pay attention not to damage the fuel level sensor (sub) and the float of the fuel level sensor (sub) when withdrawing it from the service hole.
  4. Remove the fuel level sensor (sub) mounting nuts, and remove the fuel level sensor (sub) from service hole.
  5. Replace the fuel level sensor (sub) gasket with a new one.
    CAUTION: Pay attention not to damage the fuel level sensor (sub) and the float of the fuel level sensor (sub) when installing it to the fuel tank through the service hole.
  6. Install the fuel level sensor (sub) to the fuel tank through the service hole, and tighten the mounting nuts to the specified torque.
    Fig 3: Locating Fuel Level Sensor (Sub)
    G09640860Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

    Tightening torque: 2.5 ± 0.4 N.m (22 ± 4 in-lb) 

  7. Connect the fuel level sensor (sub) connector.
  8. Install the floor inspection lid (RH).
  9. Install the rear seat cushion assembly. (Refer to REAR SEAT ASSEMBLY ).
    Fig 4: Locating Fuel Level Sensor (Sub) Connector
    G09640861Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals