>> G << Synchronizer Ring Assembly/Synchromesh Shifting Key Spring No.3 (A)/Synchromesh Shifting Key Spring No.3 (B) And Synchronizer Hub No.3 Installation

Install the synchromesh shifting key springs No. 3 onto the synchronizer ring assembly holding the claws and rotation stops of the key springs in the illustrated positions.

Fig 1: Identifying Rotation Stops
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Make sure that the rotation stops of the synchromesh shifting key springs No. 3 fit into the mating holes in the synchronizer ring assembly.

Fig 2: Locating Synchromesh Shifting Key Spring
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Compress the key springs into place inside the hub as shown.

Fig 3: Identifying Synchronizer Hub No.3 And Shifting Key Springs (A And B)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install special tool MB992220 until it hits the end face of the input shaft.

Fig 4: Installing Special Tool (MB992220)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Set special tool MB992216 on top of the synchronizer hub No. 3.

Fig 5: Setting Special Tool (MB992216)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the center bolt that is a part of the set of special tool MB992216 as shown.

Fig 6: Installing Center Bolt
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Press-fit the synchronizer hub No. 3 as shown.

Fig 7: Pressing Synchronizer Hub No. 3
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.