LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2015 >> Lancer ES, Standard Trans >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Power Steering - Lancer >> Power Steering Gear Box And Linkage >> Disassembly And Assembly >> Assembly Service Points >> Band Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Band Installation

CAUTION:
  • Secure the rack housing, and firmly crimp the bellows band by the bellows band clipping tool (special tool: MB992209 or MB992908).
  • Crimp the bellows band securely until the special tool (MB992209 or MB992908) contacts the stopper.
  1. Using the special tool (MB992209 or MB992908), crimp the bellows band.
    Fig 1: Crimping Bellows Band Using Special Tool (MB992209/MB992908)
    G07032718Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Crimping Bellows Band Using Special Tool (MB992209/MB992908)
    G09627386Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Check that the crimping width of the band (A) is within the range of the standard value.

    Standard value (A): 2.4 - 2.8 mm (0.09 - 0.11 in) 

    Fig 3: Checking Crimping Width Of Band
    G07032719Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals