Brake Pad Check
WARNING: This page is about a different variant/trim than selected.
CAUTION:
If there is a significant difference in the thicknesses of the pads on the left and right sides, check moving parts (Refer to BRAKE DISC CHECK
).
- Visually check the thickness of brake pad from the inspection hole of the caliper body.
Standard value:
9.85 mm (0.39 inch) < Front >
9.0 mm (0.35 inch) < Rear >
Limit: 2.0 mm (0.08 inch)
- When the thickness is lower than the limit value, replace both brake pads (right and left) as a set (Refer to BRAKE PAD REPLACEMENT ).