LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2015 >> Lancer Evolution Final Edition >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Manual Transaxle Overhaul) >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >> B << Synchronizer Hub No. 2 And Synchronizer Sleeve No. 2 Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

>> B << Synchronizer Hub No. 2 And Synchronizer Sleeve No. 2 Installation

WARNING: This page is about a different variant/trim than selected.
  1. Before assembly, make sure that the hub and sleeve face the correct direction.
    NOTE:
    • Apply gear oil to the caulked area between the sleeve and the hub.
    • After installation, confirm the sleeve and the hub slide smoothly.
    Fig 1: Identifying Hub And Sleeve Face Installation Direction
    G06672138Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Using special tools MD998812, MD998813, MD998820 and MD998917, install the synchronizer sleeve No. 2 and synchronizer hub No. 2.
    Fig 2: Installing Synchronizer Sleeve Using Special Tools MD998812, MD998813, MD998820 And MD998917
    G05900809Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals