Diagnostic Trouble Code Table

WARNING: This page is about a different variant/trim than selected.

CAUTION:

During troubleshooting, a DTC associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for DTC(s). If DTC(s) are stored, erase them all.
When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool MB991958, and note them. For the operation method of scan tool MB991958, refer to METER INFORMATION SWITCH CHECK . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool MB991958, follow the method described below.
1. For the driving distance for check warning, use the driving distance displayed on the multi information display.
2. For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date.

DIAGNOSTIC TROUBLE CODE TABLE

DTC No.	Diagnostic item
B1200	Malfunction of odometer
DTC B1201 < AWD > DTC B1201 < FWD >	Abnormal fuel information
B1209	Test mode
B2203	VIN not programmed
B2463	The sticking of rheostat switch
B2464	The sticking of meter information switch
B2465	Ignition switch signal error
U0019	Bus off (CAN-B)
U0100	Engine control module CAN timeout
U0141	ETACS CAN timeout
U0151	SRS-ECU CAN timeout
U0154	Occupant classification-ECU CAN timeout
U0164	A/C/Heater control unit CAN timeout
U0168	KOS-ECU or WCM CAN timeout
U1415	Coding not completed/Data fail