Individual Component Service

WARNING: This page is about a different variant/trim than selected.

WARNING:

If heat damage occurs during paint work, remove the SRS-ECU, the air bag modules, the clock spring, front seats, impact sensor and the seat belt with pre-tensioner. Recheck the SRS system operability after reinstalling them.
- SRS-ECU, air bag modules, clock spring, front seats, impact sensor: 93° C (200° F) or more
- Seat belt with pre-tensioner: 90°C (194° F) or more
If the SRS components are removed for the purpose of inspection, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.

If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in this service information . (Front impact sensor: refer to FRONT IMPACT SENSORS , SRS-ECU: refer to SRS CONTROL UNIT (SRS-ECU) , Air bag modules and clock spring: refer to DRIVER'S AIR BAG MODULE AND CLOCK SPRING , Side-airbag module: refer to FRONT SEAT ASSEMBLY , Knee air bag module: refer to KNEE AIR BAG MODULE , Side impact sensor: refer to SIDE IMPACT SENSOR , Curtain air bag module: refer to CURTAIN AIR BAG MODULE(S) , Seat belt with pre-tensioner: refer to SEAT BELTS WITH PRE-TENSIONER ).