< Vehicles with TC-SST >
WARNING: This page is about a different variant/trim than selected.
CAUTION:
After the next operation has been completed, carry out the following two operations:
- Alignment adjustment < Front >
- Steering wheel sensor (column switch assembly) replacement, removal, installation
- ASC-ECU replacement
- Update the neutral position stored in the steering wheel sensor.
- Reset the calibrated value of the steering angle stored in ASC-ECU.
- Reset the calibrated value of the steering angle stored in AWC-ECU. < Only when replace of the steering wheel sensor, removal, or installation is performed. >
CAUTION:
- Before performing the calibration, check if the steering wheel sensor-related diagnostic trouble code is set in ASC-ECU.
- When the diagnostic trouble code other than C121A is set, carry out the inspection according to each troubleshooting procedure.