LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2015 >> Lancer Evolution Final Edition >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Active Stability Control System (ASC) - With Diagnostics - Lancer Evolution) >> Wheel Speed Sensor >> Inspection >> Wheel Speed Sensor Insulation Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wheel Speed Sensor Insulation Check

WARNING: This page is about a different variant/trim than selected.
  1. Connect the circuit tester to the wheel speed sensor using the special tool extra fine probe (MB992006), and measure the insulation resistance between terminal No. 1/2 and the wheel speed sensor body as a single unit.

    Standard value: 5 MΩ or more 

  2. If the insulation resistance is not within the standard value range, replace the wheel speed sensor with a new one.
    Fig 1: Measuring Insulation Resistance Between Terminal No. 1/2 And Wheel Speed Sensor Body
    G09650922Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals