Special Tools
WARNING: This page is about a different variant/trim than selected.
| Tool | Tool number and name | Supersession | Application |
|---|---|---|---|
| MB990767 Front hub and flange yoke holder |
MB990767-01 | Fixing of the hub | |
| MB991618 Hub bolt remover |
General service tool | Removal of the hub bolt | |
| MB992700 Lock nut chisel |
General service tool | Raising up the swaged part driveshaft nut | |
| MB991897 or MB992011 Ball joint remover |
MB991113-01, MB990635-01 or General service tool | Ball joint disconnection
NOTE:
Steering linkage puller (MB990635 or MB991113) is also used to disconnect knuckle and tie rod end ball joint.
|
|
| MB990241 Axle shaft puller
|
MB990241-01 or General service tool |
|
|
| MB991354 Puller body |
General service tool | ||
| MB991721 Slide hammer |
- | Removal of the output shaft | |
A, B: Front hub remover and installer C: Spacer |
MB990998-01 |
NOTE:
MB991000, which belongs to MB990998, should be used as a spacer.
|
|
| MB990685 Torque wrench |
General service tool | Measurement of hub starting torque | |
| MB990326 Preload socket |
General service tool | ||
| MB991561 Boot band crimping tool |
MB991561 | EBJ boot (resin boot) band installation |