Pulley Removal

WARNING: This page is about a different variant/trim than selected.

Set the special tool MB992226 to the pulley.

Fig 1: Identifying Pulley With Special Tool MB992226
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Set the closed wrench to the hexagonal area of the special tool MB992226.

Fig 2: Setting Closed Wrench To Hexagonal Area Of Special Tool MB992226
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Insert the hexagonal bit socket having width across flats of 10 mm into the hexagonal area of the rotor shaft.
Hold the pulley with the closed wrench. Rotate the rotor shaft clockwise to remove the pulley.

Fig 3: Holding Pulley Using Special Tool MB992226
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.