LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2015 >> Lancer SE >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) Diagnosis & On-Vehicle Service - With Diagnostics - Lancer >> Diagnosis >> Diagnostic Trouble Code Procedures >> DTC P1723: Abnormality in Speed Sensor System Function >> Probable Causes >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

  1. STEP 1. Check the following connector: 
    • C-40 TCM connector
    • B-07 Primary pulley speed sensor connector
    • B-113 Secondary pulley speed sensor connector

    Check for the connection with terminals.

    Q: Is the check result normal? 

    1. YES:  Go to Step 2.
    2. NO:  Repair the defective connector.
  2. STEP 2. Use an oscilloscope to measure the wave patterns of the primary pulley speed sensor and secondary pulley speed sensor. 

    Refer to OSCILLOSCOPE INSPECTION PROCEDURES  .

    Q: Is the check result normal? 

    1. YES:  Go to Step 3.
    2. NO:  Replace the primary pulley speed sensor or secondary pulley speed sensor.
  3. STEP 3. Symptom recheck after erasing diagnostic trouble code 

    Q: Is the check result normal? 

    1. YES:  Intermittent malfunction
    2. NO:  Replace TCM.
scientia non olet · About LEMON Manuals