>>B<< Valve Body Assembly Installation: Notes

Install the valve body assembly on the transaxle case as follows.

1. Install the valve body harness on the valve body assembly.
   CAUTION:

   • Push in the valve body harness until the detent contacts the transaxle case.
   • Be careful not to cause damage to the terminal body.
   Fig 1: Locating Valve Body Harness

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Install the terminal body on the transaxle case, while aligning the detent of terminal body with the transaxle case as shown in the diagram.
   Fig 2: Aligning Detent Of Terminal Body

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   Fig 3: Installing Terminal Body On Transaxle Case

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Slide the valve body assembly from the left side, and install it on the transaxle case.
   Fig 4: Sliding Valve Body Assembly

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   Fig 5: Valve Body Assembly Fastening Bolts Tightening Sequence

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. Install the fastening bolts of valve body assembly, and tighten to the specified torque of 7.9 N-m (70 in-lb).

   Bolt symbol	A	B	C
   Shank length mm (inch)	54 (2.1)	44 (1.7)	54 (2.1)
   Quantity	8	1	2