INSPECTION PROCEDURE 10: The Multi-Information Display Screen Cannot Be Changed With The Operation Of The Multi-Information Display Switch: Diagnosis

STEP 1. Using scan tool (M.U.T.-III), read the combination meter diagnostic trouble code.
Check if DTC is stored in the combination meter.

CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) ."
2. Turn the ignition switch to the "ON" position.
3. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
4. Check if DTC is stored.
Q: Is the DTC stored?
1. YES: Troubleshoot the combination meter (Refer to DIAGNOSTIC TROUBLE CODE CHART ).
2. NO: Go to Step 2.
STEP 2. Check by scan tool (M.U.T.-III) "Special Function."
Using scan tool (M.U.T.-III), select "Test" from the special function of the combination meter. Execute the following item to check the liquid crystal display.
- Item 2: LCD (AUTO) (Refer to DATA LIST ).
Q: Is the check result normal?
1. YES: Go to Step 3.
2. NO: Replace the combination meter, and then go to Step 3.
STEP 3. Retest the system.
Check that the multi-information display screen works normally.

Q: Is the check result normal?
1. YES: The procedure is complete (If no malfunctions are found in all steps, an intermittent malfunction is suspected. Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTION .
2. NO: Go to Step 1.