>>A<< Engine Starting Switch Assembly Installation

1. Secure the steering lock bracket to the engine starting switch assembly with steering lock bolt (Upper). Tighten the steering lock bolt until its head is broken off.
2. Insert the engine starting switch assembly into the tip of the column shaft, fit the protrusion of the engine starting switch assembly to the hole of the steering column shaft assembly, install the engine starting switch assembly and tighten the steering lock bolt (lower) until its head is broken off.

Fig 1: Securing Steering Lock Bracket To Engine Starting Switch Assembly With Steering Lock Bolt (Upper)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION: Connect the body side wiring harness connector to the key interlock solenoid connector. Do not connect the harness connector to the key interlock solenoid dummy connector.

Fig 2: Key Interlock Solenoid, Connector, Dummy Connector And Ignition Switch

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.