LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2017 >> Mirage ES, Standard Trans >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Manual Transaxle >> Transaxle Assembly >> Removal And Installation >> Removal Service Points >> <<B>> Engine Assembly Supporting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

<<B>> Engine Assembly Supporting

  1. <When engine hanger (Special tool: MB991928) is used>
    1. Assemble the engine hanger (Special tool: MB991928). (Set the components below to the base hanger.)
      • Slide bracket (HI)
      • Foot x 4 (standard) (MB991932)
      • Joint x 2 (50) (MB991929)
    2. Set the foot of the engine hanger (Special tool: MB991928) as shown in the figure.
      NOTE: Adjust the engine hanger balance.
    3. Remove the garage jack and then remove the transaxle assembly upper part coupling bolts that have been loosened previously.
    Fig 1: Supporting Engine Assembly (1 Of 2)
    G11278091Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 2: Supporting Engine Assembly (2 Of 2)
    G11278092Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. <When engine hanger (Special tool: MB991895) and engine hanger attachment (Special tool: MB992906) are used> engine hanger (Special tool: MB991895) and engine hanger attachment (Special tool: MB992906) are used>>
    1. Set the foot of the engine hanger (Special tool: MB991895) and engine hanger attachment (Special tool: MB992906) as shown in the figure.
      NOTE: Adjust the engine hanger balance.
    2. Remove the garage jack and then remove the transaxle assembly upper part coupling bolts that have been loosened previously.
Fig 3: Supporting Engine Assembly (1 Of 2)
G11278093Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Fig 4: Supporting Engine Assembly (2 Of 2)
G11278094Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals