INSPECTION PROCEDURE 8: The Stability Control/TCL System Cannot Be Disabled When ASC OFF Switch Is Pressed For 3 Seconds Or More To Turn The System OFF: Notes
CAUTION:
- If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to CAN BUS DIAGNOSTICS TABLE .
- Whenever ECU is replaced, ensure that the CAN bus lines are normal.
- When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the G and yaw rate sensor and the steering wheel sensor (Refer to MEASURES FOR DISCHARGED BATTERY and STEERING WHEEL SENSOR CALIBRATION ).