Initialization Procedure
WARNING: This page is about a different variant/trim than selected.
- Move the selector lever to the "P" range and turn the ignition switch to the "LOCK" (OFF) position. Then, connect scan tool (M.U.T.-III) to the data link connector.
- Turn the ignition switch to the "ON" position, and then move the selector lever to the "R" range.
- Depress the accelerator pedal while depressing the brake pedal (Engine stops). Use the scan tool (M.U.T.-III) special function to execute "Reset (item number 3: C/V initial & learned value)" while holding them in applied position.
- Set the selector lever to the "P" range.
- Turn the ignition switch to the "LOCK" (OFF) position, and then wait for 10 seconds.CAUTION: Do not start the engine.
- Turn the ignition switch to the "ON" position, and then wait for 10 seconds.
- Check that "P" is displayed on the transmission range indicator on the multi-information display.NOTE: "P" will disappear while the data is being read. "P" will appear when the data reading is complete.
- Turn the ignition switch to the "LOCK" (OFF) position and then to the "ON" position. Then use the scan tool (M.U.T.-III) to erase the "CVT oil degradation level" (Refer to FLUID DETERIORATION LEVEL ERASING PROCEDURE ).