Solenoid Valve Check

WARNING: This page is about a different variant/trim than selected.

While pressing A in the figure, turn B counterclockwise to unlock the CVT assembly connector, and disconnect the connector.

Measure the resistance between the terminals of the applicable solenoid valves and ground.

Fig 1: Turning CVT Assembly Connector Counterclockwise

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

RESISTANCE VALUE SPECIFICATION

Terminal No.	Applicable solenoid valve	Resistance value Ω
1	Line pressure solenoid valve	Approximately 5.3 [Fluid temperature: 20°C (68°F)] Approximately 5.9 [Fluid temperature: 50°C (122°F)] Approximately 6.5 [Fluid temperature: 80°C (176°F)]
2	Primary pressure solenoid valve
6	Low brake solenoid valve
7	High clutch and reverse brake solenoid valve
8	Lockup solenoid valve	Approximately 6.1 [Fluid temperature: 20°C (68°F)] Approximately 6.8 [Fluid temperature: 50°C (122°F)] Approximately 7.5 [Fluid temperature: 80°C (176°F)]

CAUTION: When the resistance is outside the standard value, replace the valve body assembly (Refer to OIL PAN AND VALVE BODY ASSEMBLY ).