Key Lock Relay Check <Vehicles Without Kos>
WARNING: This page is about a different variant/trim than selected.
- Shift the selector lever to "P" position.
- Use a jumper wire to connect terminal number 5 of the selector lever assembly connector to the positive battery terminal, terminal number 6 to the negative battery terminal. Then apply battery voltage.
- Check for continuity between the selector lever assembly connector terminals number 4 and number 5.
| Jumper wire | Continuity between terminals number 4 and number 5 |
|---|---|
| Connect | Yes (Should be less than 2 ohm) |
| Disconnect | No |