Diagnostic Trouble Code Chart: Notes
CAUTION:
- During troubleshooting, a DTC associated with other system may be set when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTCs. If DTCs are set, erase them all.
- When you replace the camera-ECU, you should teach the camera-ECU for the multi-around monitor by writing a learned value. On completion, you should check the camera image on the multi around monitor "Bird's eye-view." If necessary, calibrate the camera.
- When you remove/install or replace the camera, you should check the camera image on the multi around monitor "Bird's eye-view." If necessary, calibrate the camera.
| DTC No. | Diagnostic item |
|---|---|
| B2501 | Rear view camera fault |
| B2503 | Nose view camera fault |
| B2505 | ECU internal error (EEPROM) fault |
| B2540 | CPU fault |
| B2541 | ASIC fault |
| B2542 | SDRAM fault |
| B2543 | EEPROM fault at start up |
| B2544 | Flash ROM fault |
| B2546 | LH side view CAMERA fault |
| B2547 | RH side view CAMERA fault |
| B2548 | Calibration not completed |
| B254A | Steering angle sensor fault |
| B254B | CAMERA output voltage fault |
| B254E | Camera ECU output pictures fault |
| B254F | IG status fault |
| U0100 | Engine CAN timeout |
| U0141 | ETACS CAN timeout |
| U0155 | Meter CAN timeout |
| U0245 | NAVI/DISP.AUDIO CAN timeout <vehicles with smartphone link display audio or MMCS> |
| U1195 | Coding not completed |
| U1197 | Coding data unavailable |