Lighting control sensor (rain sensor) adaptation
CAUTION:
- Before performing the adaptation, check if the lighting control sensor (rain sensor)-related diagnostic trouble code is set in the lighting control sensor (rain sensor).
- Turn the wiper switch to the OFF position.
- Clean the windshield in fine weather.
- Wipe the surface of the windshield thoroughly, and check that the surface is dry.
- Turn the ignition switch to the ON position.
- Turn the ignition switch to the LOCK (OFF) position.CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
- Connect the scan tool (M.U.T.-III) to the data link connector. Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) ."
- Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
- Wipe the windshield surface of the lighting control sensor section thoroughly, and check that the surface is dry.
- Select "LIN" on the "System Select" screen, and press the "OK" button.
- Select "Rain light sensor" on the "System Select" screen, and press the "OK" button.
- Select "Special Function" on the "Rain light sensor" screen. 11. Select "Rain Sensor Adaptation" on the "Special Function" screen.
- Press the "OK" button, and execute the "Rain Sensor Adaptation."
- Press the "OK" button after the execution screen is displayed.
- Press the "OK" button after "Completed" is displayed.