Ultrasonic MISACCELERATION Mitigation System/Corner Sensor System
- General Information
- Notes
- Construction diagram
- System block diagram
- Ultrasonic misacceleration Mitigation System function
- Operation
- Corner sensor system function
- Operation
- The Towing Bar Mode Switching
- "Corner sensor" information on the combination meter (multi-information display)
- Back Distance Warning Sensor
- Corner Clearance Sensor
- Forward Distance Warning Sensor
- When a sensor fails
- Abnormal
- Clearance warning control unit
- Forward collision mitigation system (FCM) and ultrasonic misacceleration mitigation system ON/OFF switch
- Sonar switch
- Fail-safe and diagnosis functions
- Special Tools
- Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC C2221: SONAR ECU internal tone alarm
- DTC C2223: SONAR ECU power supply voltage
- DTC C2224: FCM switch
- DTC C2225: Corner sensor switch
- DTC C2228: Steering angle sensor
- DTC C2229: Shift position abnormality
- DTC C2230: FR corner sensor signal lost
- DTC C2231: FL corner sensor signal lost
- DTC C2232: RH front sensor signal lost
- DTC C2233: LH front sensor signal lost
- DTC C2236: RR corner sensor signal lost
- DTC C2237: RL corner sensor signal lost
- DTC C2238: RH back sensor signal lost
- DTC C2239: LH back sensor signal lost
- DTC C2242: Front sensor power line
- DTC C2243: Rear sensor power line
- DTC C2245: Vehicle speed abnormality
- DTC C2246: SAS calibration not completed
- DTC C2247: Compulsion stop
- DTC U0100: Engine CAN timeout
- DTC U0101: T/M CAN timeout
- DTC U0121: ABS/ASC CAN timeout
- DTC U0126: SAS CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U1190: No receive fault detect signal
- DTC U1195: Coding not completed
- DTC U15A5: FCM/LDW/AHB CAN timeout
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Check the clearance warning control unit power supply circuit
- Inspection Procedure 2: The system cannot be switched on and off when the forward collision mitigation system (FCM) and ultrasonic misacceleration mitigation system ON/OFF switch is operated
- Inspection Procedure 3: The system cannot be activated or deactivated when you operate the sonar switch
- Data List Reference Table
- Actuator Test Table
- Check At Ecu Terminal
- Sensor
- Clearance Warning Control Unit
- Forward Collision Mitigation System (FCM) And Ultrasonic MISACCELERATION Mitigation System On/Off Switch
- Sonar Switch