Multi ARROUND Monitor
- General Information
- Notes
- Screen transition
- Function
- Bird's eye-view function
- Front-view function
- Rear-view function
- Side-view function
- Expected driving path display function
- Language setting <Vehicles without display audio, smartphone link display audio and MMCS>
- Dimmer function <Vehicle without display audio, smartphone link display audio and MMCS>
- Fail-safe function
- System configuration
- Special Tools
- Diagnosis
- Diagnostic Trouble Code Chart
- Notes
- Diagnostic Trouble Code Procedures
- DTC B2501: Rear view camera fault
- DTC B2503: Nose view camera fault
- DTC B2505: ECU internal error (EEPROM) fault
- DTC B2540: CPU fault
- DTC B2541: ASIC fault
- DTC B2542: SDRAM fault
- DTC B2543: EEPROM fault at start up
- DTC B2544: Flash ROM fault
- DTC B2546: LH side view CAMERA fault
- DTC B2547: RH side view CAMERA fault
- DTC B2548: Calibration not completed
- DTC B254A: Steering angle sensor fault
- DTC B254B: CAMERA output voltage fault
- DTC B254E: Camera ECU output pictures fault
- DTC B254F: IG status fault
- DTC U0100: Engine CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U0155: Meter CAN timeout
- DTC U0245: NAVI/DISP.AUDIO CAN timeout
- DTC U1195: Coding not completed
- DTC U1197: Coding data unavailable
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Check the camera-ECU power supply circuit
- Inspection Procedure 2: No image is displayed
- Inspection Procedure 3: Any of the camera images is blue
- Inspection Procedure 4: The image is not switched when the selector lever is moved to the R position
- Inspection Procedure 5: A screen is not switched when the vehicle speed reaches a predetermined value
- Inspection Procedure 6: A camera image is displayed when the selector lever is moved to the R position, but it is not switched when the camera switch is pressed
- Data List Reference Table
- Actuator Test Table
- Special Function
- Check At Camera-Ecu Terminal
- On-Vehicle Service