DIAGNOSTIC ITEM 31: Diagnose When The Scan Tool (M.U.T.-IIISE) Cannot Receive The Data Sent By TCU. <Vehicles With TCU>: Diagnosis

Required Special Tools: 

• MB991223: Harness Set
• MB992006: Extra Fine Probe

1. STEP 1. Connector check: joint connector (CAN5) and TCU connector 
   CAUTION: The strand end of the twist wire should be within 10 cm (3.9 inches) from the connector. For details refer to TEST EQUIPMENT  .

   When checking the joint connector, ensure that its wiring harness side and its short pins are not damaged.

   Q: Is the check result normal? 

   YES:  Go to Step  2.

   NO:  Repair the defective connector. Replace the joint connector as necessary.

2. STEP 2. Resistance measurement at joint connector (CAN5) and TCU connector. 
   CAUTION: A digital multimeter should be used. For details refer to TEST EQUIPMENT  .
   CAUTION: The test wiring harness should be used. For details refer to TEST EQUIPMENT  .
   1. Disconnect joint connector (CAN5) and the TCU connector, and measure at the wiring harness side.
   2. Turn the ignition switch to the "LOCK" (OFF) position.
      CAUTION: When measuring the resistance, disconnect the negative battery terminal. For details refer to TEST EQUIPMENT  .
   3. Ensure that the negative battery terminal is disconnected.
   4. Continuity between joint connector (CAN5) terminal No. 2 and TCU connector terminal No. 33

      OK: The resistance should be 2 ohms or less 

   5. Continuity between joint connector (CAN5) terminal No. 13 and TCU connector terminal No. 13

      OK: The resistance should be 2 ohms or less 

   CAUTION: Strictly observe the specified wiring harness repair procedure. For details refer to TEST EQUIPMENT  .

   Q: Is the check result normal? 

   YES:  <All the resistances measure 2 ohms or less> Go to Step  3.

   NO:  <Either or all of the resistances measure more than 2 ohms> Repair the wiring harness between joint connector (CAN5) and the TCU connector.

3. STEP 3. Resistance measurement at TCU connector. 
   CAUTION: A digital multimeter should be used. For details refer to TEST EQUIPMENT  .
   1. Remove the TCU, and measure at the equipment side.
   2. Resistance between TCU connector terminal Nos.33 and 13

      OK: 1 kΩ or more 

   Q: Is the check result normal? 

   YES:  Power supply to the TCU may be suspected.

   Diagnose the TCU. Refer to SYMPTOM CHART .

   NO:  Replace the TCU.