>>B<< Valve Body Assembly Installation

Install the control valve assembly on the transaxle case as follows.

1. Install the valve body harness on the control valve assembly.
   CAUTION:

   • Push in the valve body harness until the detent contacts the transaxle case  .
   • Be careful not to cause damage to the terminal body  .
   Fig 1: Locating Valve Body Harness On Valve Body Assembly

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Install the terminal body on the transaxle case, while aligning the detent of terminal body with the transaxle case as shown in the diagram.
   Fig 2: Aligning Detent Of Terminal Body With Transaxle Case

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   Fig 3: Installing Terminal Body On Transaxle Case

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. Slide the control valve assembly from the left side, and install it on the transaxle case.
   Fig 4: Installing Valve Body Assembly On Transaxle Case

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
4. Install the fastening bolts of control valve assembly, and tighten to the specified torque of 7.9 N.m (70 in-lb).

   Bolt symbol	A	B	C
   Shank length mm (inch)	54 (2.1)	44 (1.7)	54 (2.1)
   Quantity	8	1	2

   Fig 5: Valve Body Assembly Mounting Bolts

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.