Active Stability Control System (ASC)
- General Information
- Service Precautions
- Service Specifications
- Diagnosis
- Introduction To ASC Diagnosis
- ASC Diagnostic Troubleshooting Strategy
- Abs Warning Light, ASC Warning/Operation Light And Brake Warning Light Check
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC C100A: Abnormality in FL wheel speed sensor circuit
- DTC C1015: Abnormality in FR wheel speed sensor circuit
- DTC C1020: Abnormality in RL wheel speed sensor circuit
- DTC C102B: Abnormality in RR wheel speed sensor circuit
- DTC C1011: Abnormality in FL wheel speed sensor signal
- DTC C101C: Abnormality in FR wheel speed sensor signal
- DTC C1027: Abnormality in RL wheel speed sensor signal
- DTC C1032: Abnormality in RR wheel speed sensor signal
- DTC C1014: Mutual monitoring of FL wheel speed sensor
- DTC C101F: Mutual monitoring of FR wheel speed sensor
- DTC C102A: Mutual monitoring of RL wheel speed sensor
- DTC C1035: Mutual monitoring of RR wheel speed sensor
- DTC C1041: Abnormality in periodical signal for FL wheel speed sensor
- DTC C1042: Abnormality in periodical signal for FR wheel speed sensor
- DTC C1043: Abnormality in periodical signal for RL wheel speed sensor
- DTC C1044: Abnormality in periodical signal for RR wheel speed sensor
- DTC C1046: FL wheel speed sensor control phase time exceeded
- DTC C1047: FR wheel speed sensor control phase time exceeded
- DTC C1048: RL wheel speed sensor control phase time exceeded
- DTC C1049: RR wheel speed sensor control phase time exceeded
- DTC C104B: Abnormality in FL wheel inlet valve system; DTC C104F Abnormality in FR wheel inlet valve system; DTC C1053 Abnormality in RL wheel inlet valve system; DTC C1057 Abnormality in RR wheel inlet valve system; DTC C105F Abnormality in FL wheel outlet valve system; DTC C1063 Abnormality in FR wheel outlet valve system; DTC C1067 Abnormality in RL wheel outlet valve system; DTC C105B Abnormality in RR wheel outlet valve system; DTC C1200 Abnormality in FL/RR wheel cut valve system; DTC C1204 Abnormality in FR/RL wheel cut valve system; DTC C1208 Abnormality in FL/RR wheel suction valve system; DTC C120C Abnormality in FR/RL wheel suction valve system
- DTC C2104: Faulty valve power supply circuit
- DTC C1073: Faulty motor drive circuit
- DTC C2116: Low or high power supply voltage in pump motor
- DTC C121D: Abnormality in brake fluid pressure sensor circuit
- DTC C121E: Abnormality in brake fluid pressure sensor output signal
- DTC C1000: Abnormality in stoplight switch circuit
- DTC C1000 Abnormality in stoplight switch circuit
- DTC C123B: Prolonged operation of ASC
- DTC C2200: Abnormality in ASC-ECU
- DTC C2101: Abnormality in battery voltage (high voltage)
- DTC C1395: Brake fluid filling not completed
- DTC C121C: Torque request signal rejection
- DTC C2206: Re-execution of variant coding
- DTC C1210: Longitudinal G sensor input circuit
- DTC C1242: Longitudinal G sensor signal
- DTC C123C: Sensor cluster malfunction
- DTC C1392: Incomplete learn (Longitudinal G); DTC C1393: Incomplete learn neutral (Lateral G)
- DTC C2204: Sensor cluster internal error
- DTC C123A: Abnormality in sensor calibration
- DTC C1219: Abnormality in steering wheel sensor signal
- DTC C121A: Abnormality in steering wheel sensor initialization
- DTC C2205: Internal malfunction of steering wheel sensor
- DTC C2002: Valve calibration not completed
- DTC C1608: Implausible diagnosis data
- DTC C1805: FCM/LDW/AHB malfunction
- DTC C1807: FCM/LDW/AHB target deceleration signal
- DTC U0100: Engine time-out error; DTC U0101: CVT time-out error; DTC U0114: AWD time-out error; DTC U0126: Steering wheel sensor time-out error; DTC U0141: ETACS time-out error; DTC U15A5: FCM/LDW/AHB CAN timeout
- DTC U1015: FCM/LDW/AHB Parity/Toggle bit error
- DTC U1073: Bus-off
- DTC U1195: Coding not completed; DTC U1197 Coding data unavailable
- DTC U0401: Engine malfunction detected
- DTC U0428: Communication error in steering wheel sensor
- DTC U1417: Variant coding value invalid (includes faulty installation)
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Scan tool communication only with ABS/TCL/Skid control system is impossible
- Inspection Procedure 2: ASC OFF display flashes at a rate of 2Hz
- Inspection Procedure 3: Brake warning light Stays ON with the parking brake lever released
- Inspection Procedure 4: ABS warning light does not illuminate when ignition switch is turned to the ON position (engine stopped)
- Inspection Procedure 5: Brake warning light does not illuminate when the ignition switch is turned to ON position (engine stopped)
- Inspection Procedure 6: ABS warning light stays ON after the engine is started
- Inspection Procedure 7: ASC warning display stays ON after the engine is started
- Inspection Procedure 8: ASC OFF display or ASC OFF light stays ON after the engine is started
- Inspection Procedure 9: ASC Operation Display Stays ON after the Engine is Started
- Inspection Procedure 10: After ASC OFF switch is turned OFF, TCL/Skid control system cannot be disabled
- Inspection Procedure 11: Abnormality in brake operation
- Inspection Procedure 12: ASC system does not operate or faulty ASC operate
- Inspection Procedure 13: ASC-ECU power supply circuit system
- Inspection Procedure 14: Steering wheel sensor power supply circuit system
- Inspection Procedure 15: HSA (Hill Start Assist) does not work
- Inspection Procedure 16: HSA (Hill Start Assist) works on a flat road
- Inspection Procedure 17: The initial check sound of hydraulic unit is loud
- Data List Reference Table
- Actuator Test Reference Table
- Check At Ecu Terminals
- TCL/ASC Diagnosis
- Diagnosis Troubleshooting Flow
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC C1394: INCOMP. learn neutral (SAS)
- DTC C1707: Implausible coding data
- DTC C1747: Shift signal undetermined
- DTC C1750: Voltage out of range
- DTC C1751: ECU failure
- DTC C1752: Radar temperature out of range
- DTC C1753: Radar blockage detected
- DTC C1754: Radar calibration not completed
- DTC C1777: System fail detected (ASC)
- DTC C1778: Vehicle speed signal fail
- DTC C1779: Brake master cylinder PRS.signal
- DTC C1781: SAS internal fail
- DTC C1782: SAS signal fail
- DTC C1784: FCM switch fixed ON
- DTC C1787: APS signal
- DTC C1788: Longitudinal G sensor signal
- DTC C1791: Vehicle speed signal (invalid)
- DTC C1792: Brake M/C PRS. signal (invalid)
- DTC C1793: Lateral ACC. signal (invalid)
- DTC C1794: Longitudinal G signal (invalid)
- DTC C1795: Yaw rate signal (invalid)
- DTC C1796: APS signal (invalid)
- DTC C1798: FCM control disabled (ASC)
- DTC C2256: Brake switch signal fail
- DTC C2271: SAS signal fail
- DTC C2272: Delta SAS signal fail
- DTC C2276: Brake switch signal
- DTC C2292: Auto calibration out of range
- DTC C2298: Ambient sensor signal
- DTC C2299: Implausible coding data
- DTC U0100: Engine CAN timeout
- DTC U0101: T/M CAN timeout
- DTC U0121: ABS/ASC CAN timeout
- DTC U0126: SAS CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U1190: No receive fault detect signal
- DTC U1195: Coding not completed
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Scan tool communication with FCM/LDW/AHB system is impossible
- Inspection Procedure 2: The FCM cannot be turned on or off when the FCM and Ultrasonic misacceleration Mitigation System ON/OFF switch is operated
- Inspection Procedure 3: The FCM is cancelled in conjunction with a warning message while the FCM is activated
- Special Tools
- On-Vehicle Service
- Wheel Speed Sensor Output Current Measurement
- Hydraulic Unit Check
- In The Event Of A Discharged Battery
- All Sensor Calibration (G And Yaw Rate Sensor, Steering Wheel Sensor, Brake Fluid Pressure Sensor)
- G And Yaw Rate Sensor Calibration
- Steering Wheel Sensor Calibration
- Brake Fluid Pressure Sensor Calibration
- FCM/LDW/AHB-Ecu Sensor Calibration
- ASC Off Switch
- Hydraulic Unit
- Wheel Speed Sensor
- Steering Wheel Sensor
- FCM/LDW/AHB-Ecu
- Forward Collision Mitigation System (FCM) And Ultrasonic MISACCELERATION Mitigation System On/Off Switch