LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2019 >> Eclipse Cross ES, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Controller Area Network (Can) - (With Diagnostics) >> Diagnosis <Can> >> Can Bus Diagnostics >> Diagnostic Item 15: Diagnose When The Scan Tool (M.U.T.-IIISE) Cannot Receive The Data Sent By TCM >> Diagnosis
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Item 15: Diagnose When The Scan Tool (M.U.T.-IIISE) Cannot Receive The Data Sent By TCM: Diagnosis

Required Special Tools: 

  1. STEP 1. Connector check: joint connector (CAN3) and TCM connector 
    CAUTION: The strand end of the twist wire should be within 10 cm (3.9 inches) from the connector. For details Refer to TEST EQUIPMENT .

    When checking the joint connector, ensure that its wiring harness side and its short pins are not damaged.

    Q: Is the check result normal? 

    YES  : Go to Step 2.

    NO  : Repair the defective connector. Replace the joint connector as necessary.

  2. STEP 2. Resistance measurement at joint connector (CAN3) and TCM connector. 
    CAUTION: A digital multimeter should be used. For details Refer to TEST EQUIPMENT .
    CAUTION: The test wiring harness should be used. For details Refer to TEST EQUIPMENT .
    1. Disconnect joint connector (CAN3) and the TCM connector, and measure at the wiring harness side.
    2. Turn the ignition switch to the "LOCK" (OFF) position.
      CAUTION: When measuring the resistance, disconnect the negative battery terminal. For details Refer to TEST EQUIPMENT .
    3. Ensure that the negative battery terminal is disconnected.
    4. Continuity between joint connector (CAN3) terminal No. 5 and TCM connector terminal No. 9

      OK: The resistance should be 2 ohms or less 

    5. Continuity between joint connector (CAN3) terminal No. 16 and TCM connector terminal No. 10

      OK: The resistance should be 2 ohms or less 

    Q: Is the check result normal? 

    YES  : <All the resistances measure 2 ohms or less> Go to Step 3.

    NO  : <Either or all of the resistances measure more than 2 ohms> Repair the wiring harness between joint connector (CAN3) and the TCM connector.

  3. STEP 3. Resistance measurement at TCM connector. 
    CAUTION: A digital multimeter should be used. For details Refer to TEST EQUIPMENT .
    1. Remove the TCM, and measure at the equipment side.
    2. Resistance between TCM connector terminal Nos.9 and 10

      OK: 1 kΩ or more 

    Q: Is the check result normal? 

    YES  : Power supply to the TCM may be suspected. Diagnose the CVT system. Refer to SYMPTOM CHART .

    NO  : Replace the TCM.