>>A<< Drive Plate / Adapter Plate / Drive Plate Bolt Installation
- Remove the sealant, engine oil, and other adhering materials from the drive plate installation face, adapter plate, crankshaft screw hole, and drive plate bolts.
- Install the adapter plate in the direction shown in the illustration.
- Install the drive plate to the crankshaft.
- In the same manner as removal, fix the drive plate using special tool flywheel stopper (MB991883) in the same manner as removal.
- Apply a small amount of engine oil to the installation face of the drive plate bolts.
- Apply specified sealant to the drive plate bolts threads.
Specified sealant: Three Bond 1324 or equivalent
- Tighten the drive plate bolts to the specified torque in two or three steps in the order shown in the illustration.
Tightening torque: 100 ± 5 N.m (74 ± 3 ft-lb)