Diagnostic Item 26: Diagnose When The Scan Tool (M.U.T.-IIISE) Cannot Receive The Data Sent By Camera-Ecu. <Vehicles With Multi Around Monitor>: Diagnosis

Required Special Tools: 

• MB991223: Harness Set
• MB992006: Extra Fine Probe

1. STEP 1. Connector check: joint connector (CAN5) and camera-ECU connector 
   CAUTION: The strand end of the twist wire should be within 10 cm (3.9 inches) from the connector. For details Refer to TEST EQUIPMENT .

   When checking the joint connector, ensure that its wiring harness side and its short pins are not damaged.

   Q: Is the check result normal? 

   YES  : Go to Step 2.

   NO  : Repair the defective connector. Replace the joint connector as necessary.

2. STEP 2. Resistance measurement at joint connector (CAN5) and camera-ECU connector. 
   CAUTION: A digital multimeter should be used. For details Refer to TEST EQUIPMENT .
   CAUTION: The test wiring harness should be used. For details Refer to TEST EQUIPMENT .
   1. Disconnect joint connector (CAN5) and the camera-ECU connector, and measure at the wiring harness side.
   2. Turn the ignition switch to the "LOCK" (OFF) position.
      CAUTION: When measuring the resistance, disconnect the negative battery terminal. For details Refer to TEST EQUIPMENT .
   3. Ensure that the negative battery terminal is disconnected.
   4. Continuity between joint connector (CAN5) terminal No. 4 and camera-ECU connector terminal No. 1

      OK: The resistance should be 2 ohms or less 

   5. Continuity between joint connector (CAN5) terminal No. 15 and camera-ECU connector terminal No. 21

      OK: The resistance should be 2 ohms or less 

   CAUTION: Strictly observe the specified wiring harness repair procedure. For details Refer to TEST EQUIPMENT .

   Q: Is the check result normal? 

   YES  : <All the resistances measure 2 ohms or less> Go to Step 3.

   NO  : <Either or all of the resistances measure more than 2 ohms> Repair the wiring harness between joint connector (CAN5) and the camera-ECU connector.

3. STEP 3. Resistance measurement at camera-ECU connector. 
   CAUTION: A digital multimeter should be used. For details Refer to TEST EQUIPMENT .
   1. Remove the camera-ECU, and measure at the equipment side.
   2. Resistance between camera-ECU connector terminal Nos.1 and 21

      OK: 1 kΩ or more 

   Q: Is the check result normal? 

   YES  : Power supply to the camera-ECU may be suspected. Diagnose the multi around monitor. Refer to SYMPTOM CHART .

   NO  : Replace the camera-ECU.