| 14 |
Coding not comp/Setting err.flag |
The variant coding for the ETACS-ECU has not been implemented. |
Check whether DTC U1195 is set. If yes, diagnose the system according to the DTC. |
| Requirements for the calibration are not satisfied. |
Check whether the requirements for the calibration are satisfied.
- Are the calibration markers positioned correctly?
- Is a strong illumination, which a camera misinterprets as a white line on the calibration marker, emitted nearby?
|
| 15 |
Door open detection flag |
Any of the doors and liftgate are open. |
Check that any of the doors and liftgate are closed. If no, close the door or the liftgate. |
| 16 |
Front camera error flag |
The front-view camera does not recognize either of the calibration markers precisely. |
- Check the vehicle conditions.
- Are prerequisites for the calibration satisfied?
- Is the vehicle parked in a correct position?
- Is the camera lens contaminated?
- Check the calibration markers.
- Are the calibration markers positioned correctly?
- Are the calibration markers contaminated?
- Is any of the calibration markers hard to see due to a sunlight refection?
- Repeat the calibration.
|
| 17 |
Rear camera error flag |
The rear-view camera does not recognize either of the calibration markers precisely. |
| 18 |
Left side camera error flag |
The side-view camera (LH) does not recognize either of the calibration markers precisely. |
| 19 |
Right side camera error flag |
The side-view camera (RH) does not recognize either of the calibration markers precisely. |
| 20 |
Flash ROM writing error flag |
Internal malfunction of camera-ECU |
- Repeat the calibration.
- If any error code is displayed again, replace the camera-ECU (Refer to CAMERA ECU ).
- Repeat the calibration.
|
| 21 |
SD-RAM error flag |
| 22 |
EEPROM writing error flag |