How to write learned value to the camera-ECU

When the camera is replaced, write a learned value to the new camera-ECU according to the procedure below.

1. Connect scan tool (M.U.T.-IIISE) to the data link connector (For how to connect scan tool (M.U.T.-IIISE), Refer to THE DIAGNOSTIC FUNCTION ).
2. Select "Write learned value (Changed ECU)" and then "Learned value Read & save" in the special functions for the multi-around monitor system to save the learned value, which is stored in the current camera-ECU, to the scan tool (M.U.T.-IIISE).
   NOTE: If the learned value cannot be read, replace the camera-ECU and then calibrate the camera.
3. Replace the camera-ECU (Refer to CAMERA ECU ).
4. Select "Write learned value (Changed ECU)" and then "Saved learned value writing" in the special functions to write the learned value, which is stored in the scan tool (M.U.T.-IIISE), to the camera-ECU.
5. If any problems are not found on the screen, the calibration is complete. If any problem is found, calibrate the camera.