Inspection of the (-) diode
- Check the electrical continuity of the points shown in the table below. Confirm that there is not electrical continuity. If there is, replace the generator assembly.
Measured terminal No. Continuity (-) Heat sink - 1 Continuity exists. (-) Heat sink - 2 (-) Heat sink - 3 (-) Heat sink - 4 (-) Heat sink - 5 (-) Heat sink - 6 1 - (-) Heat sink No continuity 2 - (-) Heat sink 3 - (-) Heat sink 4 - (-) Heat sink 5 - (-) Heat sink 6 - (-) Heat sink