LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2019 >> Outlander ES, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Circuit Testing Procedures - Non-DTC-Based Diagnostics) >> Installation >> Connector Terminal Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Connector Terminal Installation

WARNING: This page is about a different car, the 2020 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Select a wire from the terminal repair kit that best matches the color and gauge of the wire being repaired.
  2. Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation.
  3. Splice the repair wire to the wire harness (see WIRE SPLICING  procedure).
  4. Insert the repaired wire into the connector.
  5. Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
  6. Re-tape the wire harness starting at 1-1/2 inches behind the connector and 2 inches past the repair.
  7. Connect battery and test all affected systems.
scientia non olet · About LEMON Manuals