Module, Adaptive Cruise Control (Acc): Removal

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.

Courtesy of CHRYSLER GROUP, LLC
Remove the Adaptive Cruise Control (ACC) module fascia grill cover (1) by depressing the tension tabs on each side of the cover through the grill.

Courtesy of CHRYSLER GROUP, LLC
Remove the ACC module bracket to grill fasteners (1).

Courtesy of CHRYSLER GROUP, LLC
Pull the ACC module with bracket out far enough to disconnect the wire harness connector (1) from the module.
Remove the ACC module and bracket from the vehicle.