LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2019 >> Outlander LE, AWD >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) >> On-Vehicle Service >> Electronic Control Coupling (Front) Operation Check <Vehicles With S-AWC>
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronic Control Coupling (Front) Operation Check <Vehicles With S-AWC>

  1. Raise the vehicle.
  2. For easy identification of tire rotation, mark the front and rear tires as shown in the illustration.
  3. Set the selector lever to the P position, and turn ON the ignition switch.
  4. Set the wheel to the neutral position, and carry out the special function test No. 4 "Control OFF".
  5. Rotate the left-front tire counterclockwise by your hand, and check that the right-front tire makes reverse rotation against the left-front tire.
  6. Set the shift position to the N-position, and turn ON the ignition switch.
  7. Set the wheel to the neutral position, and carry out the special function test No. 5 "Front coupling operation check".
    G13088970
    NOTE: Time limit for the special function test No. 5 "Front coupling operation check" is 1 minute.
  8. Rotate the left-front tire counterclockwise by your hand, and check that the right-front tire rotates to the same direction, viewed from the left-front tire.

    Carry out the check above. Then when the tire operates as mentioned, it is judged that the AWC-ECU control and electronic control coupling (front) are normal. If the tire does not operate as mentioned, replace the transfer assembly. (Refer to REMOVAL AND INSTALLATION <VEHICLES WITH S-AWC>  <CVT> or - TRANSFER ASSEMBLY <A/T>.)

scientia non olet · About LEMON Manuals