Module, Comfort Seat And Wheel (CSWM): Removal
WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.
- Position the passenger front seat to the full forward position.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable. Wait two minutes for the system capacitor to discharge before continuing service.
- Disconnect all wiring harness connectors (1) from the Comfort Seat and Wheel Module (CSWM) assembly (2).
- Push the release tab on the side of the CSWM and remove.