LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2019 >> Outlander LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Electronic Control Modules (Service Information)) >> Module, Door (DDM/PDM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Door (DDM/PDM): Removal

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Driver Door Module (DDM) shown in illustration, Passenger Door Module (PDM) similar.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the interior door trim panel from the front left door to access the DDM. Refer to PANEL, DOOR TRIM, REMOVAL .
    GC0183783Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect each of the door wire harness connectors (2) from the DDM (4).
  4. Remove the fasteners (3) that secure the DDM to the front door carrier plate (1).
  5. Remove the DDM from the door carrier plate.
scientia non olet · About LEMON Manuals