Module, Forward Facing Camera (FFCM): Installation

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Ensure that both inside and outside of the windshield in the area of the Forward Facing Camera (FFC) is clean of dirt, dust, or finger prints prior to installation.

Courtesy of CHRYSLER GROUP, LLC

Position the FFC and snap it into the FFC bracket. Verify that the bracket locks (1) are fully engaged.

Courtesy of CHRYSLER GROUP, LLC
Connect the wire harness connector (1) to the FFC.

Courtesy of CHRYSLER GROUP, LLC
Assemble and install the interior rear view mirror covers (1).
Connect the negative battery cable.
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.
Perform module programming. Refer to MODULE, FORWARD FACING CAMERA (FFCM), MODULE PROGRAMMING .