LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2019 >> Outlander LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Electronic Control Modules (Service Information)) >> Module, Radio Frequency (RF Hub) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Radio Frequency (RF Hub): Removal

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Pull down the rear of the headliner to gain access to the Radio Frequency Hub (RF-Hub). Refer to HEADLINER, REMOVAL .
    GC0187166Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connectors (1) and, if equipped, the antenna wire harness connector (2) from the RF-Hub.
    GC0176934Courtesy of CHRYSLER GROUP, LLC
  4. Remove the fasteners (1) securing the RF-Hub to the vehicle.
  5. Remove the RF-Hub.
scientia non olet · About LEMON Manuals