Torque Specifications

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

TORQUE SPECIFICATIONS

DESCRIPTION	Nm	Ft. Lbs.	In. Lbs.	COMMENT
Rear Drive Unit (RDU) Rear Mounting Bolt	120	89	-	-
Differential to RDU Bracket	55	41	-	-
Rear Propeller Shaft Bolts	20	15	-	Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Pump Bolts	12	-	106	-
Pressure Sensor	21	15	-	-
Bearing Plate to Intermediate Bracket Bolts	24	17	-
Rear Driveshaft Bolts	20	15	-	Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Intermediate Bracket to Engine Block and Oil Pan Bolts	65	48	-	-
Eac Bracket to Engine	55	41	-	-
Heat Shield to PTU	11	-	97	-
Front Differential Bracket to Differential	60	44	-	-
Propshaft Center Bearing to Body	10	-	88	-
Front Halfshaft to Bearing	200	148	-	Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications.
Rear Halfshaft to Bearing	175	129	-	Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications.
PTU to Transaxle	44	32.5	-	-
Mounting Bracket to Engine Block	44	32.5	-	-
Front Differential Bracket to Isolator	100	74	-	-
Final Drive Gear to Differential	163	120		-
Front Bearing to Knuckle	113	83		-
Rear Bearing to Knuckle	55 Plus 80°	41 Plus 80°	-	-
Differential Fill Plug	35	26	-	-
RDU Hydraulic Fluid Cover Bolts	6	-	53	-

1-SPEED RDM SPECIFICATIONS

DESCRIPTION	SPECIFICATION
GEAR RATIO	2.73:1
RING GEAR DIAMETER	165 mm (6.5 in.)
DIFFERENTIAL FLUID FILL CAPACITY	0.89 Liters
HYDRAULIC FLUID FILL CAPACITY	0.439 Liters