Check Of The Freeze Frame Data: Notes
Various data of when the DTC has been set is obtained, and the status of that time is stored. By analyzing each data using scan tool (M.U.T.-IIISE), troubleshooting can be carried out efficiently. Display items of the freeze frame data are as follows.
DISPLAY ITEM SPECIFICATION
| Item No. | Item | Unit/display contents |
|---|---|---|
| 1 | Odometer | km (mile) |
| 2 | Odometer (Last time fail detected) | km (mile) |
| 3 | Detection counter | times |
| 4 | Ignition cycle | times |
| 5 | ECU power supply voltage | V |
| 6 | ECU temperature | °C (°F) |
| 7 | Steering wheel angle | deg |
| 8 | Accelerator pedal position | % |
| 9 | Yaw rate | deg/s |
| 10 | AS&G status | - (Not used) |
| 11 | A.S.C. status | A.S.C. ON, A.S.C. OFF, Not defined, A.S.C. fail |
| 12 | Master cylinder pressure | MPa |
| 13 | Longitudinal G | m/s2 |
| 14 | Lateral G | m/s2 |
| 15 | Vehicle speed | km/h (mph) |
| 16 | FCM function | OFF, ON |
| 17 | RADAR blockage state | Normal, Blocked |
| 18 | FCM auto brake request | OFF, ON |
| 19 | FCM target deceleration | m/s2 |
| 20 | FCM brake prefill request | OFF, ON |
| 21 | FCM brake assist request | OFF, ON |
| 22 | FCM engine brake request | OFF, ON |
| 23 | FCM standstill request | OFF, ON |
| 24 | Brake switch | OFF, ON |
| 25 | Ignition switch | Lock, ACC, ON, Start |
| 26 | ACC set speed (unit) | km/h, mph |
| 27 | ACC system status | OFF, Standby, Active, Accel override, Temporary fail, System fail, Auto canceled, - |
| 28 | Auto brake status | Not active, ACC Braking, FCM Pre- braking, FCM Braking |
| 29 | ACC set speed | - |
| 30 | Vertical alignment angle (Current) | deg |
| 31 | Horizontal alignment angle (Current) | deg |