Disassembly And Reassembly: Notes
Required special tools:
- MB990936: Installer adapter
- MB992075: Handle
- MB992142: Oil seal installer
- MB992154: Oil seal installer
- MD998812: Installer cap
CAUTION:
- Only use transmission fluid of the specified brand. Use of transmission fluid other than specified will impair driveability and CVT endurance, and may lead to breakage of CVT.
- Only use the specified petroleum jelly. Use of vaseline other than specified will impair driveability and CVT endurance, and may lead to breakage of CVT.
- Disassembly work should be done in a clean dust-proof room.
- Prior to disassembly, clean any sand or dirt adhered to the outer parts of transaxle using steam, washing oil or another solvent, outside the clean room, so as not to contaminate inner parts of transaxle during disassembly or assembly. (Do not allow steam to get inside the transaxle, and do not clean rubber parts with washing oil.)
- After cleaning, remove the torque converter, and drain the transmission fluid.
- Disassembly and assembly work should be done with bare hands or using plastic gloves.
- Do not touch inner parts of the transaxle after touching its outer parts. (Wash hands after touching the outer parts.)
- Do not use cotton gloves and rags to prevent from lint; instead, use paper rags.
- Prior to assembly or disassembly work, make sure conditions are appropriate.
- Do not re-use the drained transmission fluid.
- When the transaxle assembly or the valve body assembly is replaced, carry out the following operations.
- Initialization procedure for CVT learned value (Refer to Initialization Procedure for CVT Learned Value.)
- Learning procedure (Refer to Learning Procedure.)
- Use only designated tool locations for a sliding hammer.
- Do not remove the pulley bearing retainer bolts (bolts for fixing pulleys and the side cover). Just turn the bolts counterclockwise 360° three times to loosen.
- Clean mating surfaces of the rims prior to applying form-in-place gasket (FIPG) sealant.
- Form-in-place gasket (FIPG) sealant should be applied to the center of the mating surfaces of the rims.
- Follow the bolt tightening sequence while it required.
- Each bearing has two sides. Check the sides of the bearing prior to installing.
- Keep flat the objects while measuring lengths, depths or heights. Measure two different points or more and use average as a measurement result value.
Pre-removal and Post-installation operation
|