>>B<<Intake Manifold/Intake Manifold Stay Installation

CAUTION: For the intake manifold mounting bolts, do not mix bolt with the washer, and flange bolt.

Install the intake manifold and intake manifold stay temporarily tighten the mounting bolts.
CAUTION: Check that the sealing surfaces of the intake manifold and intake manifold stay contact securely after temporary tightening.
Tighten the intake manifold and intake manifold stay bolts to the specified torque.
Tightening torque:

Intake manifold:
- 28 ± 2 N m (21 ± 1 ft-lb) <Bolt with the washer>
- 22 ± 1 N m (16.2 ± 0.7 ft-lb) <Flange bolt>
Intake manifold stay: 19 ± 1 N m (14.0 ± 0.7 ft-lb)