Ignition Switch Position Change Table By Push-Button Ignition Switch Operation
WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
The ignition switch position can be changed by the following operations.
NOTE:
- When an Keyless operation key is within the detection area of inside key antenna or when Keyless operation key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions.
- Brake pedal operation condition
- Selector lever position
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
| Power supply position | Condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| OFF → ON | - | Not depressed | 1 |
| OFF → ON → OFF | - | Not depressed | 2 |
| OFF → START ON → START | P or N position | Depressed | 1 |
| Engine is running → OFF | - | - | 1 |
NOTE:
If the Keyless operation key unit cannot detect that the Keyless operation key is in the vehicle, ignition switch can be turned OFF by the press and hold the push-button ignition switch for 2 seconds or more.
Vehicle speed: 4 km/h (2.5 MPH) or more
| Power supply position | Condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| Engine is running → OFF | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.